CFD Simulation of the Discharge Flow from Standard Rushton ImpellerReportar como inadecuado




CFD Simulation of the Discharge Flow from Standard Rushton Impeller - Descarga este documento en PDF. Documentación en PDF para descargar gratis. Disponible también para leer online.

International Journal of Chemical Engineering - Volume 2014 2014, Article ID 706149, 7 pages -

Research Article

Institute of Hydrodynamics AS CR, v. v. i., Pod Patankou 30-5, 166 12 Prague, Czech Republic

Department of Process Engineering, Faculty of Mechanical Engineering, Czech Technical University in Prague, Technicka 4, 166 07 Prague, Czech Republic

Received 5 August 2013; Revised 22 November 2013; Accepted 23 November 2013; Published 29 January 2014

Academic Editor: Alírio Rodrigues

Copyright © 2014 Bohuš Kysela et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Abstract

The radial discharge jet from the standard Rushton turbine was investigated by the CFD calculations and compared with results from the Laser Doppler Anemometry LDA measurements. The Large Eddy Simulation LES approach was employed with Sliding Mesh SM model of the impeller motion. The obtained velocity profiles of the mean ensemble-averaged velocity and r.m.s. values of the fluctuating velocity were compared in several distances from the impeller blades. The calculated values of mean ensemble-averaged velocities are rather in good agreement with the measured ones as well as the derived power number from calculations. However, the values of fluctuating velocities are obviously lower from LES calculations than from LDA measurements.





Autor: Bohuš Kysela, Jiří Konfršt, Ivan Fořt, and Zdeněk Chára

Fuente: https://www.hindawi.com/



DESCARGAR PDF




Documentos relacionados