Superhydrophobic Surface by Replication of Laser Micromachined Pattern in Epoxy-Alumina Nanoparticle CompositeReportar como inadecuado




Superhydrophobic Surface by Replication of Laser Micromachined Pattern in Epoxy-Alumina Nanoparticle Composite - Descarga este documento en PDF. Documentación en PDF para descargar gratis. Disponible también para leer online.

Journal of Nanomaterials - Volume 2014 2014, Article ID 547895, 11 pages -

Research ArticleDepartment of Materials Technology and Chemistry, Faculty of Chemistry, University of Lodz, Pomorska 163, 90-236 Lodz, Poland

Received 17 February 2014; Accepted 12 March 2014; Published 24 April 2014

Academic Editor: Chunyi Zhi

Copyright © 2014 Maciej Psarski et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Abstract

Superhydrophobic surfaces were obtained by superposition of microstructure—defined by replication of laser micromachined masters, with nanostructure—created by durable epoxy-γ-Al2O3 nanoparticle composite, used for replication. Hierarchical surface topography thus obtained consisted of hexagonally spaced microcavities and nanoparticle agglomerates, exposed on the replica surface by radio frequency RF air plasma etching. Surface topography was further enhanced by rims around the microcavity edges, resulting from nanosecond laser micromachining defects in aluminum masters. Subsequent wet chemical hydrophobization with 1H,1H,2H,2H-perfluorotetradecyltriethoxysilane PFTDTES provided superhydrophobic behavior in replicas with a microcavity spacing of 30 μm, as indicated by a water contact angle of 160° and a sliding angle of 8°. The preparation method is relatively simple, inexpensive, and potentially scalable.





Autor: Maciej Psarski, Jacek Marczak, Jarosław Grobelny, and Grzegorz Celichowski

Fuente: https://www.hindawi.com/



DESCARGAR PDF




Documentos relacionados