Measurement of casting parameters in ZnAlCu3 molds created by additive technologyReportar como inadecuado




Measurement of casting parameters in ZnAlCu3 molds created by additive technology - Descarga este documento en PDF. Documentación en PDF para descargar gratis. Disponible también para leer online.

Metallurgy, Vol.55 No.4 October 2016. -

This paper examines the parameters of casting ZnAl4Cu3 alloy volume, castability, density and occupancy of the mold in mold made additive technology. Molds made by additive technology are: cheaper in production of a small number of castings, geometrically more accurate and faster made. From obtained results of this paper it is clearly seen that printed mold must be protected with thermal coating because liquid adhesive of powder otherwise evaporates during casting and creates additional moisture in the mold, as it was noted.

casting; ZnAlCu3; additive technology; zirconium dioxide coating



Autor: S. Medić - ; University of Applied Sciences, Karlovac, Croatia J. Groš - ; University of Applied Sciences, Karlovac, Croatia A.

Fuente: http://hrcak.srce.hr/



DESCARGAR PDF




Documentos relacionados