Evaluation of Contact Pressure in Bending under Tension Test by a Pressure Sensitive FilmReportar como inadecuado




Evaluation of Contact Pressure in Bending under Tension Test by a Pressure Sensitive Film - Descarga este documento en PDF. Documentación en PDF para descargar gratis. Disponible también para leer online.

The contact pressure acting on the sheet-tools interface has been studied because of growing the concern about the wear of tools. Recent studies make use of numerical simulation software to evaluate and correlate this pressure with the friction and wear generated. Since there are many studies that determine the coefficient of friction in sheet metal forming by bending under tension BUT test, the contact pressure between the pin and the sheet was measured using a film that has the ability to record the applied pressure. The vertical force applied to pin was also measured. The results indicate that the vertical force is more accurate to set the contact pressure that using equations predetermined. It was also observed that the contact area between the sheet and the pin is always smaller than the area calculated geometrically. The friction coefficient was determined for the BUT test through several equations proposed by various authors in order to check if there is much variation between the results. It was observed that the friction coefficient showed little variation for each equation, and each one can be used. The material used was the commercially pure aluminum, alloy Al1100.

KEYWORDS

Coefficient of Friction, Sheet Metal Forming Process, Bending under Tension Test, Contact Pressure, Technology Applied to Design

Cite this paper

Folle, L. and Schaeffer, L. 2016 Evaluation of Contact Pressure in Bending under Tension Test by a Pressure Sensitive Film. Journal of Surface Engineered Materials and Advanced Technology, 6, 201-214. doi: 10.4236-jsemat.2016.64018.





Autor: Luis Fernando Folle1, Lirio Schaeffer2

Fuente: http://www.scirp.org/



DESCARGAR PDF




Documentos relacionados