Fabrication, Microstructure, Thermal and Electrical Properties of Copper Heat Sink CompositesReportar como inadecuado




Fabrication, Microstructure, Thermal and Electrical Properties of Copper Heat Sink Composites - Descarga este documento en PDF. Documentación en PDF para descargar gratis. Disponible también para leer online.

Copper as well as copper base composites reinforced with coated and uncoated 1 wt% diamond, graphite particles or short carbon fibers are prepared by powder metallurgy process. The reinforcement particles were encapsulated with silver as well as copper layer by using the electroless deposition technique to investigate the influence of the reinforcement surface coating on the microstructure, density, electrical and thermal properties of the sintered samples. The coated and the uncoated powders were cold compacted at 600 MPa, and then sintered at 1173 K 900°C for 2 h under hydrogen atmosphere. The phase composition, morphology and microstructure of the prepared powders as well as the copper base sintered composites were investigated using X-ray diffraction analysis XRD and Scanning Electron Microscope SEM equipped with an Energy Dispersive Spectrometer EDS respectively. The density of the sintered composites was measured by Archimedes method. The copper base consolidated composites had a density up to 96% and the reinforcement coated particles were distributed uniformly within the copper matrix better than the uncoated one. The electrical resistivity at room temperature and the heat transfer conduction of the produced samples were measured in a temperature range between 323 K 50°C and 393 K 120°C. The results observed that the sintered materials prepared from the coated powder have lower electrical resistivity than the sintered materials prepared from the mixed powders. On the other hand the thermal conductivity values were calculated using the heat transfer conduction values by means of the Fourier formula. The results observed that the thermal conductivity of copper is 391 W-m·K, 1 wt% diamond-Cu is 408 W-m·K, 1 wt% graphite coated silver-Cu is 393 W-m·K, 1 wt% Cu coated short carbon fiber-Cu is 393 W-m·K, graphite-Cu is 383 W-m·K and short carbon fiber-Cu is 382 W-m·K. The obtained composites are expected to be suitable for heat sink applications. The heat transfer testing experiments were done. The forced convection of the present work was done and compared with the previous work in the literature, and satisfactory agreement was achieved.

KEYWORDS

Heat Sink, Powder Metallurgy Matrix Composites, Electrical Resistivity, Thermal Conductivity Natural, Forced Convection

Cite this paper

Daoush, W. , Swidan, A. , El-Aziz, G. and Abdelhalim, M. 2016 Fabrication, Microstructure, Thermal and Electrical Properties of Copper Heat Sink Composites. Materials Sciences and Applications, 7, 542-561. doi: 10.4236-msa.2016.79046.





Autor: Walid Daoush1,2, Ahmed Swidan3, Gamal Abd El-Aziz4, Mohamed Abdelhalim4

Fuente: http://www.scirp.org/



DESCARGAR PDF




Documentos relacionados