Fabrication of Copper Wire Using Glyoxylic Acid Copper Complex and Laser Irradiation in AirReportar como inadecuado




Fabrication of Copper Wire Using Glyoxylic Acid Copper Complex and Laser Irradiation in Air - Descarga este documento en PDF. Documentación en PDF para descargar gratis. Disponible también para leer online.

Preparation of a glyoxylic acid copper complex and fabrication of fine copper wire by CO2 laser irradiation in air to a thin film of that complex have been investigated. Irradiating laser to the complex thin film spin-coated on a glass substrate, thin film of metallic copper was fabricated in areas that were subjected to laser irradiation in air. The thickness of this thin copper film was approx. 30 to 40 nm, and as non-irradiated areas were etched and removed by a soluble solvent of the copper complex, fine copper wire with 200 μm width was formed by laser direct patterning. The resistivity of this thin copper film depended on the irradiation intensity of the laser and was 3.0 × 10



Autor: Tomoji Ohishi*, Ryutaro Kimura

Fuente: http://www.scirp.org/



DESCARGAR PDF




Documentos relacionados