Techno-Economic Analysis of Abrasive Water-Jet Machining and Wire Electrical -Discharge MachiningReportar como inadecuado




Techno-Economic Analysis of Abrasive Water-Jet Machining and Wire Electrical -Discharge Machining - Descarga este documento en PDF. Documentación en PDF para descargar gratis. Disponible también para leer online.

Strojarstvo : journal for the theory and application in mechanical engineering = Strojarstvo : žurnal dlja mašinostroitel-noj teorii i praktik = Strojarstvo : Zeitschrift zur Theorie und Praxis des Maschinenwesens, Vol.53 No.4 August 2011. -

Nowadays, carefully selected technologies for material machining can significantly affect quality of machined surface and the cost of machining. Stainless steels are increasingly used in modern production. Austenitic stainless steels type AISI 304 including Č 4580 make up over 50% of total world production of stainless steel. Nowadays, several methods for machining of these materials are available in practice. However, some types of machining cause the change in the material properties. Machined surface quality in the function of traverse speed and costs of the stated machining methods has been selected for comparative analysis of the machining methods. This paper presents an analysis of steel machining technology 4580 type of steel with two different machining methods - abrasive water-jet and wire electrical- discharge machining. In addition, an economic analysis of the two machining methods has been conducted from the cost standpoint.

Abrasive water-jet machining: Economic analysis: Techno- technological analysis: Wire electrical-discharge machining



Autor: Srećko ĆURČIĆ - ; Technical faculty Cacak, University of Kragujevac, Čačak, Serbia Jelena BARALIĆ - ; Technical faculty Ca

Fuente: http://hrcak.srce.hr/



DESCARGAR PDF




Documentos relacionados