Cutting Force Analysis in Face Milling Using Rotatable Central Composite Design of Experiments and Taguchi MethodReportar como inadecuado




Cutting Force Analysis in Face Milling Using Rotatable Central Composite Design of Experiments and Taguchi Method - Descarga este documento en PDF. Documentación en PDF para descargar gratis. Disponible también para leer online.

Strojarstvo : journal for the theory and application in mechanical engineering = Strojarstvo : žurnal dlja mašinostroitel-noj teorii i praktik = Strojarstvo : Zeitschrift zur Theorie und Praxis des Maschinenwesens, Vol.53 No.4 August 2011. -

This paper presents a study of the influence of cutting conditions on the cutting force components during face milling of steel 42CrMo4. Two experimental plans, rotatable central composite design and the Taguchi method with orthogonal arrays and signal-to-noise ratio, have been designed and performed on controlled machining with corresponding cutting conditions. Equations for the cutting force components, as a functions of cutting parameters, have been obtained by means of regression analysis. The Taguchi method has been used to analyse impact of cutting parameters on the cutting force components and to find optimal level of the cutting parameters. The comparison of results obtained by means of the rotatable central composite design and the Taguchi method was performed.

Cutting forces; Design of experiments; Face milling; Regression analysis; Taguchi method



Autor: Dražen BAJIĆ - ; Faculty of Electrical Engineering, Mechanical Engineering and Naval Architecture, University of Split, Split,

Fuente: http://hrcak.srce.hr/



DESCARGAR PDF




Documentos relacionados