A Numerical Approach on Reduction of Young’s Modulus During Deformation of Sheet MetalsReportar como inadecuado




A Numerical Approach on Reduction of Young’s Modulus During Deformation of Sheet Metals - Descarga este documento en PDF. Documentación en PDF para descargar gratis. Disponible también para leer online.

The paper investigates the elastic behavior of the metal after unloading. For this purpose the strip of metal with tensile gauge length was simulated with high and low strength material. Further the channel forming was modeled for combination of materials to predict the spring-back and compared the results. It is observed that the Young’s modulus E-value decreases with the increase in plastic strain. The strength of the material has no effect on the decrease in the E-value after unloading during tension test. However in channel forming the E-value after unloading depends on the starting E-value, spring-back angle and maximum strain achieved in the channel. The proposed mathematical equations to determine the E-value after unloading from the tension test and channel forming test gives very good prediction with each other. It is also found that the lowest spring-back occurred in the channel with the composite Hard-Soft material.

KEYWORDS

Elasticity; Spring-Back; Channel Forming; Optimization; Deformation

Cite this paper

C. Nikhare -A Numerical Approach on Reduction of Young’s Modulus During Deformation of Sheet Metals,- Modeling and Numerical Simulation of Material Science, Vol. 2 No. 1, 2012, pp. 1-13. doi: 10.4236-mnsms.2012.21001.





Autor: Chetan Nikhare

Fuente: http://www.scirp.org/



DESCARGAR PDF




Documentos relacionados