Investigation of Micro Square Structure Fabrication by Applying Textured Cutting Tool in WEDMReportar como inadecuado




Investigation of Micro Square Structure Fabrication by Applying Textured Cutting Tool in WEDM - Descarga este documento en PDF. Documentación en PDF para descargar gratis. Disponible también para leer online.

Engineering Research Center of Extreme Precision Optics, State Key Laboratory of Applied Optics, Changchun Institute of Optics, Fine Mechanics and Physics, Chinese Academy of Science, Changchun 130033, China





*

Author to whom correspondence should be addressed.



Academic Editor: Miko Elwenspoek

Abstract This paper studies micro structure fabrication by means of a textured tool cutting edge, which is manufactured by applying the wire cut electrical discharge machining WEDM. Machining performance of the square structure fabrication on the tool cutting edge is investigated in the WEDM process, and the machining accuracy is explored in experimental analyses. In this proposed method, undesired overcut comes from the discharge between the processing debris and the side wall of the target structure. Furthermore, by applying the textured cutting tool, the target square structure is directly fabricated on the alumina workpiece with just a simple turning process, which verifies the feasibility of the proposed tool cutting edge textured method by applying the WEDM. This technology is expected to become a potential method for the mass production of micro structure surfaces in the future. View Full-Text

Keywords: textured tool cutting edge; WEDM; micro structure; turning textured tool cutting edge; WEDM; micro structure; turning





Autor: Jianguo Zhang * , Quansong Li, Hui Zhang, Yongxin Sui and Huaijiang Yang

Fuente: http://mdpi.com/



DESCARGAR PDF




Documentos relacionados