Development of Integrally Molded Bipolar Plates for All-Vanadium Redox Flow BatteriesReportar como inadecuado




Development of Integrally Molded Bipolar Plates for All-Vanadium Redox Flow Batteries - Descarga este documento en PDF. Documentación en PDF para descargar gratis. Disponible también para leer online.

1

Advanced Institute of Manufacturing with High-tech Innovations and Department of Mechanical Engineering, National Chung Cheng University, No. 168, University Rd., Minhsiung Township, Chiayi 62102, Taiwan

2

Institute of Nuclear Energy Research, Atomic Energy Council, No. 1000 Wenhua Rd., Jiaan Village, Longtan Township, Taoyuan 32546, Taiwan





*

Author to whom correspondence should be addressed.



Academic Editor: Xiaoliang Wei

Abstract All-vanadium redox flow batteries VRBs are potential energy storage systems for renewable power sources because of their flexible design, deep discharge capacity, quick response time, and long cycle life. To minimize the energy loss due to the shunt current, in a traditional design, a flow field is machined on two electrically insulated frames with a graphite plate in between. A traditional bipolar plate BP of a VRB consists of many components, and thus, the assembly process is time consuming. In this study, an integrally molded BP is designed and fabricated to minimize the manufacturing cost. First, the effects of the mold design and injection parameters on frame formability were analyzed by simulation. Second, a new graphite plate design for integral molding was proposed, and finally, two integrally molded BPs were fabricated and compared. Results show that gate position significantly affects air traps and the maximum volume shrinkage occurs at the corners of a BP. The volume shrinkage can be reduced using a large graphite plate embedded within the frame. View Full-Text

Keywords: all-vanadium redox flow battery VRBs; bipolar plate BP; injection molding; energy storage all-vanadium redox flow battery VRBs; bipolar plate BP; injection molding; energy storage





Autor: Chih-Hsun Chang 1, Han-Wen Chou 2, Ning-Yih Hsu 2 and Yong-Song Chen 1,*

Fuente: http://mdpi.com/



DESCARGAR PDF




Documentos relacionados