Effect of Chopped Basalt Fibers on the Mechanical Properties and Microstructure of High Performance Fiber Reinforced ConcreteReportar como inadecuado

Effect of Chopped Basalt Fibers on the Mechanical Properties and Microstructure of High Performance Fiber Reinforced Concrete - Descarga este documento en PDF. Documentación en PDF para descargar gratis. Disponible también para leer online.

Advances in Materials Science and Engineering - Volume 2014 2014, Article ID 587686, 14 pages -

Research ArticleCivil Engineering Department, Universiti Teknologi PETRONAS, Bandar Seri Iskandar, 31750 Tronoh, Perak, Malaysia

Received 14 April 2014; Revised 30 June 2014; Accepted 2 July 2014; Published 13 October 2014

Academic Editor: Lian Gao

Copyright © 2014 Tehmina Ayub et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.


This paper presents the mechanical properties and the microstructure of the high performance fiber reinforced concrete HPFRC containing up to 3% volume fraction of chopped Basalt fibers. Three types of the concrete were prepared, out of which, the first type was prepared by utilizing 100% cement content. The other two types of the concrete were prepared by replacing 10% cement content with silica fume and the locally produced metakaolin. Using each concrete type, four mixes were prepared in which Basalt fibers were added in the range of 0–3%; that is, total twelve mixes of the HPFRC concrete were prepared. From each of the twelve concrete mixes, total twelve specimens were cast to determine the mechanical properties of the HPFRC including compressive strength cube and cylinder, splitting tensile strength, and the flexural strength. In this way, a total of 108 specimens were cast and tested in this study. Test results showed that the addition of the Basalt fibers significantly increased the tensile splitting strength and the flexural strength of the HPFRC, while there was slight improvement in the compressive strength with the addition of Basalt fibers. The microstructure of HPFRC was examined to determine the interfacial transition zone ITZ between the aggregates and the paste by using field emission scanning electron microscope FESEM, which showed the improvement of the ITZ due to the addition of the Basalt fibers.

Autor: Tehmina Ayub, Nasir Shafiq, and M. Fadhil Nuruddin

Fuente: https://www.hindawi.com/


Documentos relacionados