Frequency-Division Multiplexing for Electrical Impedance Tomography in Biomedical ApplicationsReportar como inadecuado




Frequency-Division Multiplexing for Electrical Impedance Tomography in Biomedical Applications - Descarga este documento en PDF. Documentación en PDF para descargar gratis. Disponible también para leer online.

International Journal of Biomedical Imaging - Volume 2007 2007, Article ID 54798, 9 pages

Research Article

School of Computer Science and Engineering, Hebrew University of Jerusalem, 78b Ross Building, Jerusalem 91904, Israel

Biophysics Graduate Group, University of California, Berkeley, CA 94720-3200, USA

Department of Mechanical Engineering, University of California, Berkeley, CA 94720-1740, USA

Received 22 September 2006; Revised 22 March 2007; Accepted 8 July 2007

Academic Editor: Richard Bayford

Copyright © 2007 Yair Granot et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Abstract

Electrical impedance tomography EIT produces an image of the electrical impedance distribution of tissues in the body, using electrodes that are placed on the periphery of the imaged area. These electrodes inject currents and measure voltages and from these data, the impedance can be computed. Traditional EIT systems usually inject current patterns in a serial manner which means that the impedance is computed from data collected at slightly different times. It is usually also a time-consuming process. In this paper, we propose a method for collecting data concurrently from all of the current patterns in biomedical applications of EIT. This is achieved by injecting current through all of the current injecting electrodes simultaneously, and measuring all of the resulting voltages at once. The signals from various current injecting electrodes are separated by injecting different frequencies through each electrode. This is called frequency-division multiplexing FDM. At the voltage measurement electrodes, the voltage related to each current injecting electrode is isolated by using Fourier decomposition. In biomedical applications, using different frequencies has important implications due to dispersions as the tissue-s electrical properties change with frequency. Another significant issue arises when we are recording data in a dynamic environment where the properties change very fast. This method allows simultaneous measurements of all the current patterns, which may be important in applications where the tissue changes occur in the same time scale as the measurement. We discuss the FDM EIT method from the biomedical point of view and show results obtained with a simple experimental system.





Autor: Yair Granot, Antoni Ivorra, and Boris Rubinsky

Fuente: https://www.hindawi.com/



DESCARGAR PDF




Documentos relacionados