Shrink-fitting and dowel welding in mortise and tenon structural wood jointsReportar como inadecuado




Shrink-fitting and dowel welding in mortise and tenon structural wood joints - Descarga este documento en PDF. Documentación en PDF para descargar gratis. Disponible también para leer online.

1 LERMAB - Laboratoire d-Etude et de Recherche sur le Matériau Bois 2 CRAN - Centre de Recherche en Automatique de Nancy

Abstract : Shrink-fitting, a common bonding technique in metal assemblies, was used for mortise and tenon wood joints. The joints had considerable strength. Shrink-fitting yielded joint strengths comparable to those obtained by using several welded dowels. Increasing the number of welded dowels, however, produced joints of higher strength than those bonded just by shrink-fitting. Combining in the same joint both dowel welding and shrink-fitting yielded joint strengths higher than those obtained by the individual techniques alone, and at the same time allowing decreasing the number of welded dowels needed.

Keywords : Shrink-fitting wood welding mortise and tenon joint dowel welding joint strength





Autor: Eric Mougel - Carlos Segovia - Antonio Pizzi - André Thomas -

Fuente: https://hal.archives-ouvertes.fr/



DESCARGAR PDF




Documentos relacionados