Formulation and Evaluation of Transdermal Patch of RepaglinideReportar como inadecuado




Formulation and Evaluation of Transdermal Patch of Repaglinide - Descarga este documento en PDF. Documentación en PDF para descargar gratis. Disponible también para leer online.

ISRN PharmaceuticsVolume 2011 2011, Article ID 651909, 9 pages

Research ArticleDepartment of Pharmaceutics, Shri Sarvajanik Pharmacy College, Gujarat, Mehsana 384001, India

Received 15 April 2011; Accepted 17 May 2011

Academic Editors: M. Moneghini and J. Torrado

Copyright © 2011 Shailesh T. Prajapati et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Abstract

Repaglinide has the half life of 1 hour, and bioavailability in the body is 56% due to first-pass metabolism. The total daily dose of Repaglinide is 16 mg e.g., 4 mg four times daily depending on meal patterns; hence, it required frequent dosing. Transdermal patch of Repaglinide was prepared to sustain the release and improve bioavailability of drug and patient compliance. Different formulations were prepared by varying the grades of HPMC and concentration of PVP K30 by solvent casting method. The prepared formulations were evaluated for various parameters like thickness, tensile strength, folding endurance, % elongation, % moisture content, % moisture uptake, % drug content, in vitro drug release, in vitro permeation, and drug excipient compatibility. A 3

full factorial design was applied to check the effect of varying the grades of HPMC 𝑋1 and PVP concentration 𝑋2 on the responses, that is, tensile strength, percentage drug released in 1 hr 𝑄1, 9 hr 𝑄9, and diffusion coefficient as a dependent variables. In vitro release data were fitted to various models to ascertain kinetic of drug release. Regression analysis and analysis of variance were performed for dependent variables. The results of the F2 statistics between factorial design batches and theoretical profile were used to select optimized batch. Batch F6 was considered optimum batch which contained HPMC K100 and PVP 1.5%, showed release 92.343% up to 12 hr, and was more similar to the theoretical predicted dissolution profile 𝑓2=69.187.





Autor: Shailesh T. Prajapati, Charmi G. Patel, and Chhagan N. Patel

Fuente: https://www.hindawi.com/



DESCARGAR PDF




Documentos relacionados