Construction Materials Used in the Historical Roman Era Bath in MyraReportar como inadecuado




Construction Materials Used in the Historical Roman Era Bath in Myra - Descarga este documento en PDF. Documentación en PDF para descargar gratis. Disponible también para leer online.

The Scientific World Journal - Volume 2014 2014, Article ID 536105, 9 pages -

Research Article

Vocational School of Technical Sciences, Akdeniz University, 07058 Antalya, Turkey

Department of Civil Engineering, Akdeniz University, 07058 Antalya, Turkey

Received 3 April 2014; Accepted 9 June 2014; Published 26 June 2014

Academic Editor: İlker Bekir Topçu

Copyright © 2014 Cem Oguz et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Abstract

The physical, chemical, and mechanical properties of mortars and bricks used in the historical building that was erected at Myra within the boundaries of Antalya Province during the Roman time were investigated. The sample picked points were marked on the air photographs and plans of the buildings and samples were photographed. Then petrographic evaluation was made by stereo microscope on the polished surfaces of construction materials mortar, brick taken from such historical buildings in laboratory condition. Also, microstructural analyses SEM-EDX, XRD, physical analyses unit volume, water absorption by mass, water absorption by volume, specific mass, compacity, and porosity, chemical analyses acid loss and sieve analysis, salt analyses, pH, protein, fat, pozzolanic activity, and conductivity analyses, and mechanical experiments compressive strength, point loading test, and tensile strength at bending were applied and the obtained results were evaluated. It was observed that good adherence was provided between the binder and the aggregate in mortars. It was also detected that bricks have preserved their originality against environmental, atmospheric, and physicochemical effects and their mechanical properties showed that they were produced by appropriate techniques.





Autor: Cem Oguz, Fikret Turker, and Niyazi Ugur Kockal

Fuente: https://www.hindawi.com/



DESCARGAR PDF




Documentos relacionados