Chip Thickness and Microhardness Prediction Models during Turning of Medium Carbon SteelReport as inadecuate

Chip Thickness and Microhardness Prediction Models during Turning of Medium Carbon Steel - Download this document for free, or read online. Document in PDF available to download.

Journal of Applied Mathematics - Volume 2007 2007, Article ID 51905, 12 pages

Research Article

Department of Mechanical & Industrial Engineering, Applied Science University, P.O. Box 926296, Shafa-Badran, Amman 11931, Jordan

P.O. Box 830342, Amman 11183, Jordan

Received 1 March 2007; Accepted 11 July 2007

Academic Editor: Ibrahim Sadek

Copyright © 2007 S. A. Alrabii and L. Y. Zumot. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.


Cutting tests were conducted to medium carbon steel using HSS tools with cutting fluid. The experimental design used was based on response surface methodology RSM using a central composite design. Chips were collected at different machining conditions and thickness and microhardness measurements taken and analyzed using “DESIGN EXPERT 7” experimental design software. Mathematical models of the responses thickness and microhardness as functions of the conditions speed, feed, and depth of cut were obtained and studied. The resultant second-order models show chip thickness increases when increasing feed and speed, while increasing depth of cut resulted in a little effect on chip thickness. Chip microhardness increases with increasing depth of cut. It also increases with increasing speed and feed up to a certain level beyond which further increases cause a drop in microhardness.

Author: S. A. Alrabii and L. Y. Zumot



Related documents