Pneumatic Formwork Systems in Structural EngineeringReportar como inadecuado




Pneumatic Formwork Systems in Structural Engineering - Descarga este documento en PDF. Documentación en PDF para descargar gratis. Disponible también para leer online.

Advances in Materials Science and Engineering - Volume 2016 2016, Article ID 4724036, 13 pages -

Research ArticleInstitute for Structural Engineering, TU Vienna, Karlsplatz 13, E212-2, 1040 Vienna, Austria

Received 17 June 2016; Accepted 10 July 2016

Academic Editor: João M. P. Q. Delgado

Copyright © 2016 Benjamin Kromoser and Patrick Huber. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Abstract

Concrete as a construction material is characterized by high compressive strength, low tensile strength, and good casting ability. In order to fully utilize the potential of this material, the form of load-carrying structures has to be designed according to the stress distribution in the structure. Partially hollow structures, such as hollow beams, or doubly curved structures, such as shells, have favorable characteristics. In hollow structures, material savings are achieved in the individual building components by locally reducing dimensions. Concrete shells, if designed properly, are able to span over large areas by transferring the loads mainly by membrane stresses. The main problem with these structures, however, is the high effort required for producing the complicated formwork. One possibility of reducing this effort is to use a pneumatic formwork. This paper describes different pneumatic formwork systems invented in the past 100 years and presents the latest developments in this area. The many types of possible applications are divided into three categories in order to obtain a clearer overview. Finally, a new construction method, called -Pneumatic Forming of Hardened Concrete PFHC,- is presented. This method was invented at the TU Vienna and uses the pneumatic formwork in a novel way.





Autor: Benjamin Kromoser and Patrick Huber

Fuente: https://www.hindawi.com/



DESCARGAR PDF




Documentos relacionados