Optimum combination of process parameters to optimize surface roughness and chip thickness during end milling of aluminium 6351 -t6 alloy using taguchi grey relational analysis Reportar como inadecuado




Optimum combination of process parameters to optimize surface roughness and chip thickness during end milling of aluminium 6351 -t6 alloy using taguchi grey relational analysis - Descarga este documento en PDF. Documentación en PDF para descargar gratis. Disponible también para leer online.

Independent Journal of Management & Production 2017, 8 2

Autor: Reddy Sreenivasulu

Fuente: http://www.redalyc.org/articulo.oa?id=449551140003


Introducción



Independent Journal of Management & Production E-ISSN: 2236-269X ijmp@ijmp.jor.br Instituto Federal de Educação, Ciência e Tecnologia de São Paulo Brasil Sreenivasulu, Reddy OPTIMUM COMBINATION OF PROCESS PARAMETERS TO OPTIMIZE SURFACE ROUGHNESS AND CHIP THICKNESS DURING END MILLING OF ALUMINIUM 6351 T6 ALLOY USING TAGUCHI GREY RELATIONAL ANALYSIS Independent Journal of Management & Production, vol.
8, núm.
2, abril-junio, 2017, pp. 287-298 Instituto Federal de Educação, Ciência e Tecnologia de São Paulo Avaré, Brasil Available in: http:--www.redalyc.org-articulo.oa?id=449551140003 How to cite Complete issue More information about this article Journals homepage in redalyc.org Scientific Information System Network of Scientific Journals from Latin America, the Caribbean, Spain and Portugal Non-profit academic project, developed under the open access initiative INDEPENDENT JOURNAL OF MANAGEMENT & PRODUCTION (IJM&P) http:--www.ijmp.jor.br v.
8, n.
2, April - June 2017 ISSN: 2236-269X DOI: 10.14807-ijmp.v8i2.325 OPTIMUM COMBINATION OF PROCESS PARAMETERS TO OPTIMIZE SURFACE ROUGHNESS AND CHIP THICKNESS DURING END MILLING OF ALUMINIUM 6351-T6 ALLOY USING TAGUCHI GREY RELATIONAL ANALYSIS Reddy Sreenivasulu Department of Mechanical Engineering, R.V.R&J.C College of Engineering (Autonomous), INDIA E Mail: rslu1431@gmail.com Submission: 30-09-2016 Revision: 15-10-2016 Accept: 23-10-2016 ABSTRACT In any machining operations, quality is the important conflicting objective.
In order to give assurance for high productivity, some extent of quality has to be compromised.
Similarly productivity will be decreased while the efforts are channelized to enhance quality.
In this study, the experiments were carried out on a CNC vertical machining center (KENT and INDIA Co.
Ltd, Taiwan make) to perform 10mm slots on Al 6351-T6 alloy work piece by K10 carbide, four flute end milling cutter as per taguchi design of experiments plan by L9 orthogonal array was choosen to dete...





Documentos relacionados